Home > VBOX Automotive > FAS-Anwendungen > ADAS Troubleshooting Guide > Re-Setting Contact Points

Re-Setting Contact Points

Keine Header

Use the VBOX Manager to clear the subject and target vehicle contact points. Your range data will then revert back to antenna to antenna separation. 


Once cleared, re-apply the contact points using one of the methods below:


1. Set contact points by plotting positions

2. Manually apply contact points

3. Load contact points


Note: If calculating data in both subject and target vehicle (duplex) ensure you perform sync to target after setting CONTACT POINT.


Are you using a single point of contact with apply points method? If so, then set point 2 to match point 1 


Has this fixed your problem?




Zuletzt geändert



Diese Seite verfügt über keine Klassifikationen.
Having trouble finding what you need?